There is nothing worse than having a luxury wet room hours and cause leakage of moisture. The following guide is how professionals in the tank of a wet room. And the tank for you and for me is water resistant.
Paredes
It begins with a first call on a keraprimer i. clean and dry e. Gypsum Board. Primer diluted 1:1 with water and let it dry for at least 1 hour before sealing with latex, fiberglass material called kerafibre.
Kerafibre Stir well before use and increased use of material in the corners, joints and screw heads, brush kerafiber on the tape and make sure it is thoroughly wet. The use of pipeline capacity tape input (cutting the hole), press the review of costs kerafiber and brush to make sure kerafiber wet. Apply the first layer kerafiber in the area of the entire wall, and then let it dry for at least 4 hours before applying the second coat. Kerafiber changes to a darker color when dried.
Kerafiber Apply second coat and let dry for 6-12 hours before tiling. Check the thickness of the layer and applying additional points kerafiber fine or porous, and then dried again. The required amount kerafiber min. 0. 1/m2 and 6 min. Thickness of the layer o. 4 mm.
Home plow the second lowest row of tiles, and at least 10 cm of soil. Set the pictures on the wall with tile adhesive superfix.
Flats
Keraprimer Apply to a clean, dry diluting 1:1 with water first. Use tape reinforcement at corners, joints and screw heads on the tape kerafiber brush and make sure it is thoroughly wet.
Using crossLAN building materials to seal the drain in the floor. Brush a sheet on the floor with a toothbrush kerafiber, and then another in the first well with a brush and kerafiber.
Apply kerafiber around the floor drain (40×40cm) and turn the double sheet of reinforcement in the drain. Kerafiber Apply a layer on any surface and allow to dry for at least 2 hours (kerafiber changes color as it dries).
Apply a second coat of kerafiber and let dry for 6-12 hours before tiling. Check the thickness of the layer and applying additional points kerafiber thin or porous. Let dry. Kerafiber amount is 0. 1/m2 and 8 min and the thickness of the layer must be 0. 5mm.
Once dry, cut the drain hole in the ground. Make sure the hole diameter is at least 40 mm shorter than the diameter of the drain. This ensures that the edge of the hole reaches the seal of the floor drain. The kerafiber mantle must be at least 1. 5 mm thick around the leak.
Click a tension ring compatible with the care of the floor drain and cut off any additional membrane tension below the ring. Kerafiber brush the entire surface until the voltage tension ring ring gasket / silicone drain output.
Set the tiles on the tile floor superfix. Fill the joints with glue tile to wait 15-30 minutes and wash the excess grout from tile with a sponge. Wring the towel and the excess water can discolor joints.
Wipe the excess grout and silicone used on all seams and corners. Let stand for 24 hours to dry completely. Calefacción por suelo radiante se puede utilizar poco a poco después de una semana de la junta.